PulseGuard Ltd. and Inc.
PulseGuard Ltd. offers pulsation dampers | Please phone 44(0) 161-480-9625
We have people not voicemail | Call toll free UK 08080-567-7423
Fluid Flow Control Animations
Fluid Flow Control Animations

Low Volumetric Efficiency, or lost motion -
& - Pumping with a Velocity Jump. "The Joukowski Shock"

Lost Motion damper with a LP Flexorber detailed color cut sheet

When the beginning of the forward stroke does not displace any liquid, a pressure shock is emitted, instead of a flow surge.
The shock is caused by the acceleration away from "bottom dead center" before it hits solid liquid.
This acceleration without pumping liquid is caused in 3 ways:
1. Expansion of compressible liquid left form he last discharge stroke, stopping the pump filling properly on its suction stroke.
2. Volume control by limiting back stroke, as in some cam drives.
3. Instant action as from a solenoid drive.
The shock from all three occurs too fast, for an off line flow smoother to catch.
These shocks are bad for all forms of instrumentation, and usually cause pipe shake as well.
An in line through flow damper is needed to intercept the shocks.

Transients from one pump head,
disturb the check valves of the next.

Multiplex Diaphragm with LP and HP FLexorbers cross sectional color cut sheet

When volumetric efficiency is less than 93%, the level of shock and pressure pulsation become greater can be tolerated by adjacent check valves.
Beware of hot and compressible liquids.

To prevent pressure transients in t he suction line from breaking the liquid column into alternate slugs and voids, it is essential to intercept and remove the transients.

This may be achieved by placing a flow-through pressure pulsation interceptor individually in the line to each check valve, or one central damper, as shown here, with non interconnected pipes leading to a piping base block.

what this looks like Real picture of What this looks like

This prevents the check valve from one cylinder "talking" to an adjacent cylinder, causing it to open when it should be close, and creating an even greater fall in efficiency.

Similarly, in the discharge system, the extreme levels of discharge shock that comes from low efficiency, not only destabilizes valves that should be re-seating, but also makes control by feedback from instruments a near impossibility.

The rule is never to use a normal "manifold", they create the maximum interaction.

Find Your Factor for your Pump System GO TO find your factor for your pump system


FUN fun way

PulseGuard Ltd. and Inc.
To top of page
Return to Smoothness Level
to smoothness level

Return to the beginning of PulseGuard, pulsation dampeners

Selecting Pulsation Dampeners for Different Pump Systems.
Flow through pulsation dampers are at least 3 times more efficient than T off line accumulators.
Dampeners that do, flow goes through, but pressure pulsation does not.
PulseGuard Pulsation DampersThe Smooth Flow People

Call Toll Free 1-888-DAMPERS (326-7377) / See also: Pulsation-Dampeners.com for a pulsation dampener.

Fluid Flow Control Fluid-Flow-Control.com The Fluid Flow Control Source Pumps Accumulators Filters Dampers Heat Exchangers Valves Mixers P.I. / Pressure Indicators Controls Meters Vessels